Installation Instructions
(INNO Keyless &
Electronic Deadbolt)
Step 1 Drill Holes
Drill a
2-1/8”(54mm) hole on door face from both sides just
below the mortise lock.
Step 2 Install Cylinder
Install
the cylinder provided by us. In case of existing mortise lock, the existing
cylinder is to be replaced with ours.
Step 3 Install Bracket
1. Install the Internal Body Bracket vertically
and adjust the position of bracket as the center of cylinder crank having
torque blade to be even with the center of bracket main hole.
2. Tighten the bracket on the door
with 4 screws.
Step 4 Install External Body
1. Insert harness of external body
into the door hole and pull it out to opposite side through the slip of
internal body bracket.
2. Insert rivets of back plate of
external body into door hole until external body touches door face.
3. Insert machine screws through the
center slip of internal body bracket, engaging holes of rivets of external body
and tighten them firmly.
4. If machine screws are not enough
to hold firmly then use the longer one.
Step 5 Install Internal Body
1. Connect harness from external body
with connector on PCB of Internal Body.
2. Connect the harness of magnet
sensor with connector on PCB.
3. Fix internal body to the bracket
with 4 screws.
4. Find the proper position of magnet
sensor beside or below internal body and fix it with 2 screws.
5. Fix the magnet at the position on
door frame facing the magnet sensor.
Step 6 Choose Motor Direction
1. The motor direction of the lock is set at Left Hand (LH) door from the factory.
2. Remove battery cover and load 4 batteries and test the lock by touching Open/Close Button.
3. If motor direction is not properly adjusted, the automatic locking function will not work. In this case, please change the motor direction.
4. To adjust motor direction from LH to Right Hand (RH) door, push 123 button under battery cover at internal body and push “7” on keypad for 5 seconds until it sounds.
5. To adjust motor direction from RH to LH door, push 123 button under battery cover of internal body and push “7” on keypad for 5 seconds until it sounds.
IP Europe Kft.
www.innolock.eu